S120正常运行几个月后，这几天S120中的一个伺服轴在运行过程中出现报警，代码为F07490。
S120为CU320,驱动器为6SL3120.报警有时是在停止时，有时是在轴运行中。
报警内容如下：
请高人指点一下怎么办。
F07490 EPOS: Enable signal withdrawn while traversing
Drive objects:
SERVO, VECTOR
Response:
OFF1 (OFF2, OFF3)
Acknowledgement:
IMMEDIATELY
Cause:
- for a standard assignment, another fault may have occurred as a result of withdrawing the enable signals.
- the drive is in the "switching on inhibited" state (for a standard assignment).
Remedy:
- set the enable signals or check the cause of the fault that first occurred and then result (for a standard assignment).
- check the assignment to enable the basic positioning function.
最佳答案
F07490——运行时，使能信号取消导致该故障。
检查一下，在设备运行时，是否由于某些因素导致该使能信号丢失。
提问者对于答案的评价：
hao
原创文章，作者：more0621，如若转载，请注明出处：https://www.zhaoplc.com/plc202157.html
微信扫一扫 
支付宝扫一扫